Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2018 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Help; Flywheel position; 700

posted by  pcarduc1 on  Thu Apr 29 19:40 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Please help;
I have a 91 740 turbo. The original motor had to be replaced. I found a 87 740 turbo with a rebuilt motor so I bought it. I swapped the motors. The only component I left on the 87 motor was the distributor. Everything else is from the 91. Intake,turbo with exhaust manifold,flywheel etc. My problem is this. When I swapped the flywheels, I didn't set the flywheel up right in relation to the timing or the crankshaft position sensor. My question I need answered is where should the flywheel be bolted or set when I'm at TDC?

Please help Pat.







  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Help; Flywheel position; 700

    posted by  someone claiming to be charles on  Fri Apr 30 02:18 CST 2004 [RELATED]

    hi pat.go to the FAQ ,clik on (engine mechanical0 then on (flywheel position on reinstallation).hope that helps.good luck.charles.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.