Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2022 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

temperature compensation board bypass successful 200 1986

posted by  someone claiming to be kamakunga on  Tue Mar 16 10:12 CST 2004 [RELATED]

thanks to this post http://www.brickboard.com/RWD/index.htm?id=746268

it was an easy job to remove and jump the terminals.

not having soldering experience I pulled two connecters off the board and soldered them to each end of my jumper wire then pushed them onto the
pins, this helped to keep them in place as i soldered them to the pins.

Robert

86 245 174,000 mile self locking odometer ,Rust Hole high flow cabin air intake sysem, Silicone Goop wiring harness, Multi Sway t.a. bushings, Duct Tape spanned rear bumper to body, Terrerium wheel wells.

91 nissan 4cyl truck 258,000 miles








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    temperature compensation board bypass successful 200 1986

    posted by  someone claiming to be twoforty on  Tue Mar 16 13:32 CST 2004 [RELATED]

    I like the movement....I'd rather see the ongoing rise and fall of my engine temp than see spikes. Sure would be nice to install a degree reading.....saaay, why not get one from an older british car, sender and all.
    New project for the warmer weather.....12-18" of new snow happening.

    Twofortty








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    temperature compensation board bypass successful 200 1986

    posted by  yama on  Tue Mar 16 11:48 CST 2004
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Oct 25 05:26 CST 2013
    [RELATED]

    Are you seeing more movement in your temperature gauge? I rather have an accurate reading.
    --
    1990 240 Sdn 277K,tach,strut brace,turbo sway 1990 240 Wgn M47II 157K,tach,strut brace,poly bushings,IPD sways








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      temperature compensation board bypass successful 200 1986

      posted by  kamakunga on  Tue Mar 16 12:00 CST 2004
      Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

      I havent warmed up the car yet. I'll post about it later.
      I would like to have a gauge that showed temp in actual numbers.

      I kept the board in case I wanted to re -install it

      Aloha

      86 245 174,000 mile self locking odometer ,Rust Hole high flow cabin air intake sysem, Silicone Goop wiring harness, Multi Sway t.a. bushings, Duct Tape spanned rear bumper to body, Terrerium wheel wells.

      91 nissan 4cyl truck 258,000 miles








<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.