Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2014 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

intake manifold removal 200

posted by  someone claiming to be jerrjl on  Thu Jul 31 02:17 CST 2003 [RELATED]

i was try to remove the intake manifold to replace the gasket, but i found some of the bolts holding it in place are difficult to get to. is there any special tool required to perform the job? this is also true for one of the bolt holding down throttle body(the one near to the throttle position sensor).








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    intake manifold removal 200

    posted by  raidman on  Thu Jul 31 03:07 CST 2003
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Apr 4 22:17 CST 2014
    [RELATED]

    Jerr:
    try a 13mm box end wrench, some have a bend that helps. I have had to remove stuff(like the air intake) under the manifold to allow my hands to reach in with the wrench. Also you may use a 3/8" U-joint on your socket.
    Buena suerte,
    el RaidmaN







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.