Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2014 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

High Tension Leads 760 Repalce? 700

posted by  someone claiming to be yabbiecars on  Tue May 27 15:22 CST 2003 [RELATED]


Hi,
Does anyone know the best method of replacing High Tension Leads for a PRV6?
Due to the rediculous placement of the Distributor underneath the Fuel
Distributor not a lot of attention was made for enough room to remove.
Do I have to remove the whole cap and replace?
Oh this Car!!!







  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    High Tension Leads 760 Repalce? 700

    posted by  rmagoo on  Wed May 28 03:49 CST 2003
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

    if you do them one at a time carefully you can change them but it takes a while. if you want a little more room remove the two 5 mm allen screws on plenums that the brackets holding the distributor attach with. and put a small socket under the bracket to give you about a half inch more clearance. be careful it has a plastic and rubber gasket by the throttle housing you dont want to break, if your gentle, ive done this a lot of times and no problems.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.