Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Clutch replacement ... 700 1991

posted by  Kane on  Thu May 22 17:45 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Rolled 200k yesterday ... so this weekend, I'll be replacing the (original!) clutch/plate/throwout bearing/pilot bearing, and of course, the rear main seal ... anything else to consider while the tranny's out?

The flywheel will be resurfaced or exchanged for one that's done already.

-- Kane
--
Blossom II - '91 745Ti/M46 ... Bubbles - '74 144GL/BW35 ... Buttercup - '86 245GL/AW70 ... The Wayback Machine - '64 P220/M40








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Clutch replacement ... 700 1991

    posted by  balu on  Thu May 22 18:40 CST 2003
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Jun 21 12:44 CST 2013
    [RELATED]

    Kane,

    You probably already know this, but the impulse sender for the igniton gets its signal from the flywheel in your car, so you have to put the flywheel back in the same position as it was. If you exchange it, you must get one from a car with the same system ('89 and later NA, '90 and later Turbos).
    Good time to look at the shifter bushings, too.
    HTH,

    Balu
    --
    '89 780T, 223k mi; '80 245, 364k mi







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.