Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

M 4 output shaft

uid 5322's pic
posted by  alschnertz on  Wed Apr 30 00:01 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:32 CST 2014
[RELATED]

Does anyone know the thread size for the output shaft on a M 4 4sp trans? The locknut has cracked and trial and error for a replacement has become frustrating.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    M 4 output shaft 444-544

    posted by  walrus3 on  Wed Apr 30 02:24 CST 2003
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Mon Dec 2 14:20 CST 2013
    [RELATED]

    I don't know the size but it is very likely metric and you could certainly
    check it with a micrometer and a pitch gage.
    --
    George Downs, The "original" Walrus3, Bartlesville, Oklahoma








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      M 4 output shaft 444-544

      posted by  rmagoo on  Wed Apr 30 03:06 CST 2003
      Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

      actually i think most of the threads used on those old cars was standard. very little metric i can think of, they didnt switch over to metric til about 1974 or so. but definitely use a pitch guage and micrometer or caliper to be sure.








      •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

        M 4 output shaft 444-544

        posted by  walrus3 on  Wed Apr 30 03:27 CST 2003
        Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
        last visit: Mon Dec 2 14:20 CST 2013
        [RELATED]

        The 122 and the 140/164 used unified threads but my 544s and my 444
        were all, or nearly all, metric.
        --
        George Downs, The "original" Walrus3, Bartlesville, Oklahoma







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.