Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Power Antenna Mast from FCP Groton 200 1991

Hi,

Noticed that FCP Groton sells a replacement mast for the 240 for around $16--which is a good bit cheaper than my local dealer. Anyone have any experience with these? Curious as to quality, fit, and ease of installation . . .

Thanks in advance,

Steve A-








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Power Antenna Mast from FCP Groton 200 1991

    A little OT here, but when I got my '85 sedan it came with the power antenna motor assembly with a broken antenna. So I got the FCP part to replace it at some point and it was easy to install but I'm curious, is it supposed to stick up about 4-5" because mine does? Since I never saw the stock one I don't know. As for quality it seems great.
    Thanks








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Power Antenna Mast from FCP Groton 200 1991

      Hmmm...I don't think it should extend 4-5"...the stock one runs flush with the base of the mast...not sure that helps. I'm installing the FCP Groton one tomorrow so will post results.
      -Adam
      --
      '92 244GL silver-metallic, 141k, Hella 550 Front Fogs, K&N filter w/modded box (no thermostat, and screens), Bilstein HDs w/strut plates, IPD anti-sway bars and upper and lower chassis braces, Volvo 240 OEM rear wing/spoiler, Unitek cam and header sooooon








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Power Antenna Mast from FCP Groton 200 1991

    They work great and are dead ringers for the original.








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Power Antenna Mast from FCP Groton 200 1991

      Good to know...just got the same one in the mail from FCP Groton today...installing tomorrow!
      --
      '92 244GL silver-metallic, 141k, Hella 550 Front Fogs, K&N filter w/modded box (no thermostat, and screens), Bilstein HDs w/strut plates, IPD anti-sway bars and upper and lower chassis braces, Volvo 240 OEM rear wing/spoiler, Unitek cam and header sooooon







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.