Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2019 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Wheel well chrome trim 700

Does anyone know how to remove/replace the wheel well chrome trim piece on an '86 740? The rear driver side one on my '86 740 is bent and coming off. I can't see quite how it is removed. There are plenty of replacements available at the junkyard, but I need to get one and put it on without destroying it.

thanks
740man








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Wheel well chrome trim 700 1988

    If you mean the thin strip of chrome(plastic I think)trim that is about a 1/4'' wide, then they are sorta "glued" on with the same adhesive that the Volvo badges and whatnot are put on with. The best way to remove it is wait for a hot day and then use a "blow dryer" to heat up the strip to make the adhesive easier to remove, and then get some sort of solvent(goo gone or the like) to remove the leftover adhesive. I'm going to tell you now, it's a bit** to remove that adhesive crap. I removed the trim from two of the fenderwells so far and it has taken quite some time to get rid of the adhesive. I'm not replacing mine, just getting rid of it all together to give the car a cleaner look. Hope this helps.


    matt f.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.