Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2005 120-130 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Auto to standard, how was yours done? ( I only know the Volvo I know) 120-130

OK, I'm taking a little survey on the auto to standard swap. Mainly dealing with the crossmember.

The PO welded 1/2" plate steel extensions on the old auto crossmember on to which is bolted a standard tranny crossmember. However it looks like the old crossmember is going to interfere with an M41 J-type which I am gearing up to install.

So I'm trying to be ready to deal with removing the PO's mod to allow installation of the OD and will obviously need somewhere to mount the M41. Planning on using the crossmember he used for the M40 but remember its current attachment will disappear with the old crossmember.

Anyway just curious as to how the crossmember location has been dealt with by others to allow OD in an originally auto 122.

I know I can't be the only one.

Thanks,

-Mario








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Auto to standard, how was yours done? ( I only know the Volvo I know) 120-130

ˇOjalá que pudiera ayudarte! Pero es que NUNCA he tenido un Volvo automático.
--
George Downs, The "original" Walrus3, Bartlesville, Oklahoma







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.