Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2004 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

244GL Dashboard light 200 1983

My dashboard Bulb out yellow light flashes on briefly for 1/2 second whenever I hit my brakes. I've checked ALL lights on the vehicle and they all work great, but why does the light go on only when I hit the brakes. It's just an annoyance.

Thanks,
Dale








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    244GL Dashboard light 200 1983

    Hi Dale, my car does the same thing :-). All the lights work fine, but the light will flicker or stay on sometimes. You can also take a light sandpaper and clean the bulb socket connections with it. Also use a small wire brush to clean inside the bulb socket. Lightly sand the copper ring where the socket screws onto place on. This will give it a better connection. Take care. Michael








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    244GL Dashboard light 200 1983

    they work, but they are not EXACTLY the same. For the 1st 1/2 second, the resistances are different. When the filaments are hot, the resistance is the same, so the warning light goes out.

    Go buy a pack of 2 bulbs. Replace the brake bulbs with two matching bulbs and your problem will go away.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.