Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 2/2003 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

windshield rubber replacement 200 1981

From reading archives, 91 and up glass with flush trim can be retrofitted to earlier cars. Is this a combined unit, or can you reuse existing glass with new flush trim? Also, does this apply for rear window as well?








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    windshield rubber replacement 200 1981

    Hi

    I think the windshield is reusable when retrofitting the flush trim. The old non flush trim is secured to the glass by clips - there are a lot of them I suppose. Remove them and let a shop install the flush trim on the windshield.
    You should only be very careful not to damage the windshield when removing the old trim and those clips.

    If your car is a wagon the whole tailgate has to be replaced when retrofitting the 90+ style rear window, because on later models with flush glass,the window opening is somehow different. The 90+ tailgate will fit without problems, only the hose to the washer nozzle has to be rerouted, given that the 90+ have the nozzle mounted on top of the gate.

    If you have the sedan I donīt know if the rear window could be modified in any way.

    Good luck and lots of greetings

    Ciao M.P.









<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.