Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 2/2003 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear Upper Spring Mount Bolt Size???????? 200 1987

I need to know the lenght and width at threads of the bolt holding the rear upper spring mount (See part #9 in picture.) Will work the weekend with an idea to lift the car rear. Will post solution if it works. :)

I need this info in order to buy longer bolts than stock.

Thanks.
As this is a metric bolt please state size in mm or cm.

--
1987 - 240 DL 76k mi









  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Rear Upper Spring Mount Bolt Size???????? 200 1987

    sorry, i don't know the bolt size but i'm interest in your lifting ideas. i imagine you lengthened the torque rods and panhard bar?
    --
    required on checks








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Rear Upper Spring Mount Bolt Size???????? 200 1987

      The idea follows.

      1. Make a 1/2 steel spacer 4" diameter with a 1/2" hole in the center.
      2. Put that spacer over the Rear Upper Spring Mount.
      3. You will need a longer bolt to tighten the mount.

      A friend told me it works...

      I will tell you later ifit does...
      --
      1987 - 240 DL 76k mi







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.