Volvo RWD 700 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 12/2000 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Swapping 95' engine into 89' 745T 700

Next weekend I will begin swapping a low mileage 95' B230ft into my wagon. What parts do I have to switch over? I am concerned about possible differences in the distibutor, flywheel, engine sensors. Can I use the ones that came with the engine, or substitute mine ? Thanks for any insight.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Swapping 95' engine into 89' 745T 700

    As Chris already mentioned, transfer the sensors if any numbers don't match. Count the holes in the flywheels - if there are the same number of holes leave it, otherwise transfer it.

    Bram








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Swapping 95' engine into 89' 745T 700

    Substitute the engine sensors and the distributor. You'll have to take off the crankshaft sensor bracket on the 95 (if it still has it) so that it'll fit.

    If the knock sensors have the same numbers, leave them. Otherwise switch those too.

    The swap is easy (a lot of work, but straightforward).
    --
    Chris Herbst, near Chicago.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.