Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2002 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Hall sender 200 1982

What are the characteristics of a failing Hall sender? How can I test it? My 82 B21F, Chrysler ignition, falters at idle and at speed and occasionally stalls at idle. Two local independent Volvo shops have thrown up their hands and suggested possible bad Hall sender or ICU. They don't think there is a wiring harness problem. Bentley doesn't help me on this. I've checked the archives with limited success. Any help appreciated.

Phillip








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Hall sender 200 1982

    Why do they suspect its not the wiring harness, this could be a very likely cause. a volvo shop should know that between 81-87 the wiring harnesses can be a suspect for MOST intermitant problems.


    MRE


    --
    '82 DL - 150k, '93 940 - 93k








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Have you checked the obvious stuff? 200 1990

    ignition coil, wires, distributor....all those three sound like it could be related to ignition stuff. When my 240 started stalling at idle and had loss of power, I traced it to the ignition coil. Where the wire going to the distributor came out, the contact had rotted away. It wasn't easily noticeable. Pull out the cables and inspect them.

    good luck

    SM
    90 BMW 325is
    98 BMW 528i
    90 Volvo 240DL







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.