Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

CIS module 85 245GLT 200 1985

posted by  someone claiming to be john on  Sun Dec 10 17:01 CST 2000 [RELATED]

My CIS control module is not working..I have checked all items ie: air valve, coolant sensor, throttle switch, power, etc. The original module

fried,the second module shows no signs of failure but I cannot adjust the

idle correctly..grounding # 10 blu/wht..Is it the module?? Thanks..

The car looks good/runs GREAT...so.california..







  REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: CIS module 85 245GLT 200 1985

posted by  someone claiming to be Paul Seminara on  Mon Dec 11 03:05 CST 2000 [RELATED]

How is your wire harness? I mean I have seen dead CIS idle modules, but they didn't just fry themselves, usually a short in the wire harness did them in. Unplug at firewall and module connectors and start metering. Are you following the Bentley procedure for base idle adjust?







  REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: CIS module 85 245GLT 200 1985

posted by  someone claiming to be Don Foster on  Sun Dec 10 22:49 CST 2000 [RELATED]

When I had trouble with the idle on my '82 turbo, it turned out to be an intermittent throttle switch. Even though it always clicked, sometimes it didn't make electrical contact, sometimes it did. A replacement switched solved it.



Don Foster (near Cape Cod, MA)






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.