Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

B21-F engine goes out of time 200 82

posted by  someone claiming to be Keith Shostrom on  Fri Oct 19 10:51 CST 2001 [RELATED]

This has happened 3 times. After starting cold engine, engine dies and will not restart. Ignition timing is found to be about 15 degrees off. The timing gear has been found to be one or two cogs off on the timing belt. After re-timing, the car runs fine for awhile and then it happens again, even with new timing belt. Belt tensioner is OK.

Mechanic has pulled the distributor and oil pump and removed the shaft that drives them. This shaft is supported by 3 bearing in the block. The center bearing lubrication hole is open, but this bearing appears rough, other bearings look OK. Shaft journals appear OK. Mechanic thinks that this shaft periodicaly seizes for just a second causing the timing belt to slip a cog or two.

Has anyone out there experienced or heard of this problem? We need all the help we can get. Thanks.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B21-F engine goes out of time [200][82]
posted by  someone claiming to be Keith Shostrom  on Fri Oct 19 10:51 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.