Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2009 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How to remove the clutch throwout bearing? 200 81

posted by  someone claiming to be Rob Kuhlman on  Tue Oct 17 11:27 CST 2000 [RELATED]

I'm almost ready to swap M46s in my '81 245. In prepping the new one, I wanted to remove the clutch throwout bearing and put my old (only 3 years) bearing in its place when I get the old trans out on Thursday. But...I must be blind or something, but I can't see how to remove the bearing from the throwout arm. Bentley is silent, and Haines mentions something about a spring clip, but there's no diagram, and I can't see what it is I'm looking for.

Could someone please shed some light on this for me. Thanks a million!

Rob







  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: How to remove the clutch throwout bearing? 200 81

posted by  someone claiming to be Rene Svastal on  Tue Oct 17 13:06 CST 2000 [RELATED]

On my M46 from an 82DL, there is a small bolt on the outside of the bell housing which holds the release fork at the pivoting end. By unscrewing the bolt you can move the fork out enough that the bearing slides off the shaft, then the bearing just slips off the fork. That's on my limited experiance though.

Rene






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.