Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2009 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

oil sending unit wires 200 1984

posted by  someone claiming to be Jim Haffner on  Sun Jul 18 21:00 CST 1999 [RELATED]

I have an '84 DL which just has the idiot lights. I found a turbo car at the wreckers with the oil and volt gauges in it. I also got the oil sending unit. It has two prongs on it. The wire diagram I have shows the green wire from the gauge going to the sending unit, but there is suppose to be a black wire from the sending unit going to where I don't know. The wire diagram doesn't show where this wire goes. I have a Bently and Haynes manual and both are a grid type diagram. Does any one know where this black wire from the sending unit goes? Also has anyone done this before? And if so is there anything I need to know to make these gauges work.

Thanks,

Jim at JMandJD@juno.com







  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: oil sending unit wires 200 1984

posted by  someone claiming to be roberthaire on  Sun Jul 18 23:48 CST 1999 [RELATED]

I think that is your existing idiot light wire terminal. That way you have both the gauge and the light functional.






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.