Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Hyd Press, Bearings & Bushings 200 86

posted by  someone claiming to be Doug Blalock on  Thu May 17 09:32 CST 2001 [RELATED]

I have a new set of rear axle bearings for '86 240DL as well as front susp bushing kit. Since the closest place I can find to press off/on the axle bearings wants $30/side to do it, I was thinking it might be worth buying a hydraulic press from one of the discount tool companies, and using it on the front bushings too. OK, maybe its just an excuse to buy another tool. The question is what ton press do I need and what is the minimum distance needed to press off the axle bearings? Choices are 12 ton ($110) to 20 ton ($230) presses with 23" and 32" working distances. Any advice from the experienced?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hyd Press, Bearings &amp; Bushings [200][86]
posted by  someone claiming to be Doug Blalock  on Thu May 17 09:32 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.