Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Rear Passenger Tail Light 200 1993

Hello

It seems so simple, it's driving me crazy. The rear passenger tail light is out. I have replaced the fuse as well as the bulb to no avail. All other objects on the fuse(5) function. I have also taken the bulb from the drivers side (which works) and plugged it into the passenger side. Still does not work. Using an Ohm meter, there is no juice getting to this socket. Any suggestions?

Thank you Kindly,

TK








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Re: Rear Passenger Tail Light 200 1993

    Common problem is bad connection between the flexible plastic printed circuit and the contacts on the twist in bulb holder. Which bulb is out? Is it wired parllel with the other side? If yes then problem must be in the wiring between the two sets of lights.

    BTW hope you checked for voltage with voltmeter function and not ohms function.








    •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

      Re: Rear Passenger Tail Light 200 1993

      Sand gently with fine sandpaper the metal connectors on the bulb holders and the bulb and don't forget the ground connector also. Use pencil eraser for the cleaning of the plastic printed circuit. Good luck







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.