Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2007 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

intake manifold gasket 700 1985

How can I tell if the manifold gasket is defective?

thanks,

Bob H.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Re: intake manifold gasket 700 1985

    If the gasket IS bad, replace it with a VOLVO gasket. They are much softer than aftermarket and I imagine they seals much better.

    Rene









  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Re: intake manifold gasket 700 1985

    Easy test is to start the engine and spray around the manifold gasket with carb cleaner. If engine idle changes at a particular area, you've found your leak.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Re: intake manifold gasket 700 1985

    You can look around the edges of the intake manifold to look for breaks.

    If your idle increases and decreases, surges, you have a vacuum leak.

    Remove the manifold and check it.

    Retorque the manifold to about 20 - 30 ft-lbs.

    Easy.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.