Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2004 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Engine rebuild valve shim question. 700 88

posted by  someone claiming to be Rene Svastal on  Mon Apr 23 12:28 CST 2001 [RELATED]

I would like to know if it isn't easier to just measure the clearances and then remove the camshaft for shim swaping/replacement.

Its a 530 B230FT head that was rebuilt but the guy/jerk didn't do the shims. The head is sitting on my bench so there's no timing belt to worry about.

Thanks,

Rene







  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Re: Engine rebuild valve shim question. 700 88

    posted by  someone claiming to be Pete Fluitman on  Mon Apr 23 13:28 CST 2001 [RELATED]

    That method works for me. I usually leave the little rubber springs between the valve stem and the bucket off until I have the gaps right. Its very easy to let those little suckers lead you down the garden path.

    Regards







    •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

      Re: Engine rebuild valve shim question. 700 88

      posted by  someone claiming to be Rene Svastal on  Mon Apr 23 16:55 CST 2001 [RELATED]

      OK Thanks.

      Rene






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.