Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2010 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Rear window nozzle - how to repair? 200 1993

posted by  woodshavings on  Wed Sep 29 21:22 CST 2021
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 08:22 CST 2014
[RELATED]

The rear window nozzle no longer holds securely in the hatch, and hangs out enough to let water in. The 'fingers' that hold it in place have broken from age (I think). The nozzle works fine, so it would be great if there was a way to secure it.

What have others done to keep the nozzle secured to the rear hatch?

I've looked for a replacement, but no one seems to have them. Any sources I could try?

Thanks!







  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Rear window nozzle - how to repair? 200 1993

    posted by  rstarkie on  Thu Sep 30 03:26 CST 2021
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Oct 24 10:14 CST 2014
    [RELATED]

    I would use silicone. I think you would find it to both seal against water getting in as well as holding it in place.

    My preference would be "clear" but black is readily available in small tubes at auto supply stores.
    --
    Any twenty minute job is just a broken bolt away from a three day ordeal







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.