Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2009 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

windshield washer spray spigot install? 1800

posted by  Whale on  Fri Jan 15 15:47 CST 2021
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jun 14 19:52 CST 2013
[RELATED]

I am trying to replace a missing windshield spray nozzle on my 70 1800E. The issue is trying to install the securing nut/fixture to the spray nozzle from below the double panel through a lower 1" access hole. The threaded nozzle extension is too short to provide a start below the lower panel to thread the securing nut, so I keep dropping it. Once you drop the nut it can float unretrievable in the cavity! I was lucky the first time it happened, as I was able to fish out the nut after 30 minutes with a piece of hooked wire. I assume it shouldn't be that difficult if you know the secret procedure. It is not in a manual. Any tips?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New windshield washer spray spigot install? [1800]
posted by  Whale subscriber  on Fri Jan 15 15:47 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.