Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2015 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Volvo b230k hall sensor cable to ecu 700

Hi hasanyone got the part no for the cable 3 wires from the hall sensor socket to the ecu ,just rebuilt the head now started but the male pins seem to have gone south oh deep joy Steve uk.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Volvo b230k hall sensor cable to ecu 700

    I cannot help with a part number - try a dealer - even if you have to use the web.

    If you do try a repair, make sure you solder all connections.

    When you say the pins have gone south, do you mean that they have pushed back into the plug?

    If so, each pin has a tang on it that is used to hold it in the plug.

    This happens to mass air sensors because they are unplugged whenever the air cleaner is serviced.

    You can fashion a small tool to press the tang down and remove the pin from the plug and carefully bend the tang a bit so that it will hold.

    If a pin has been pushed back, you may be able to just pull it out. After I repaired my mass air sensor plug, I marked the wires with a marker so that I could tell if any of the pins had been pushed back after I plugged it in.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.