Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Difficult a/c v-belt install after spontaneous ejection 200 1987

posted by  Kindofhandy on  Thu Oct 11 13:48 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

1. Funny noise while on the interstate. Power steering disappears. After arrival at destination, crank pully (HB) --> AC compressor v-belt found sitting on splashguard, twisted around it's axis and looking like a mobius strip (but not infinite). No cracking or tears, but evidence of trauma to both outer edges of belt and traces of rubber on crank pulley (HB).

2. With adjustments fully loose for both p/s pump and a/c compressor, can't get a/c compressor close enough to engine to get replacement belt on. Tried with two different belts, both #17385 (1/2" x 39 1/8").

clues:

Pulleys aren't lined up perfect, but they're not too far off. About 6 months ago I replaced all of the accessory bushings with HD (but not poly) bushings from IPD. All the v-belts went on fine then.

The harmonic balancer is not separated from rubber center. The old one went out about a year ago and was replaced with a good JY one along with a timing belt change. The inner and outer portions are marked and the marks haven't moved.

Ideas? TIA.

-KoH






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Difficult a/c v-belt install after spontaneous ejection [200][1987]
posted by  Kindofhandy subscriber  on Thu Oct 11 13:48 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.