Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2003 1800 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

coil connection 1800 1967

posted by  voice122 on  Wed May 16 18:52 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 00:08 CST 2014
[RELATED]

Still battling with my coil issue

Is there a way to connect a standard coil without cutting into the armoured cable

Should i try straight to the battery to see if the coil works

Any issues

Thanks again








  REPLY TO THIS MESSAGE    PRINT   SAVE 

coil connection 1800 1967

posted by  voice122 on  Thu May 17 03:20 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 00:08 CST 2014
[RELATED]

Thanks
i intend to do the same








  REPLY TO THIS MESSAGE    PRINT   SAVE 

coil connection 1800 1967

posted by  voice122 on  Wed May 16 22:22 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 00:08 CST 2014
[RELATED]

Thanks Eric

I cut through the armored cable and connected the wire to the + terminal on the new coil

My original coil was dead anyway

I will see how it all works tomorrow

David








  REPLY TO THIS MESSAGE    PRINT   SAVE 

coil connection 1800 1967

posted by  planetman on  Wed May 16 22:33 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:29 CST 2014
[RELATED]

FYI, when I am forced to replace the coil with a non-original assembly, I usually re-purpose the original coil housing to hold the new coil.



--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502
hiperformanceautoservice.com or oldvolvosonly.com








  REPLY TO THIS MESSAGE    PRINT   SAVE 

coil connection 1800 1967

posted by  planetman on  Wed May 16 21:18 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:29 CST 2014
[RELATED]

To test the new coil, use a couple of jumper wires.

Connect the small wire that is connected to your old coil to the "-" terminal on the new coil.

Connect the "+" terminal on the coil to the battery and try to start the engine. Be aware that once you get the engine started you will have to disconnect this or the other jumper wire to stop the engine.
--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502
hiperformanceautoservice.com or oldvolvosonly.com







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.