Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Wiring Ignition Switched 12V Accessory 200 1986

Hi,

Was wondering where's the best place to wire in a 12V accessory that I want to turn on when the ignition is on? I want to put it on the #1 radio fuse for my 86 240 but I don't think anyone makes an add a fuse for torpedo type fuses. I don't wanna cut and solder in on another wire if I can help it. Anyone dunnit?

Thanks,

Mike








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Wiring Ignition Switched 12V Accessory 200 1986

    I've always been able to find a spare, unused terminal on the load side of the fuse holder, but if you find the one you want to use full, you can get a piggyback 1/4" Faston like illustrated in #12 below.







    --
    Art Benstein near Baltimore

    "I haven't had any tooth decay yet," said Tom precariously.








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Wiring Ignition Switched 12V Accessory 200 1986

      Art the man! Thanks a lot, great schematics/photos. I didn't know that all those blades on the right side are spares good old volvo. I got it all wired up on my #1 radio fuse and it works! Thanks again!


      Mike







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.