Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2018 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

What do I measure? (control arm stay bushing) 700

Wrenching on a 1990 745 regina. I am wanting to replace the control arm stay bushings but I am unsure of what I am supposed to measure so I am sure I get the correct bushing? As far as I know, the control arm is original and is made of aluminum... What am I supposed to measure to determine whether its 385mm,390.5mm or 396mm?

Thanks for the help.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

What do I measure? (control arm stay bushing) 700

I think you measure from the center of the bolt hole to the end of the threaded rod. I cant remember when I did mine last which one I had. They are pretty cheap from FCP.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

What do I measure? (control arm stay bushing) 700

Call FCP. Those guys/gals are a lot of help. Go with poly.
--
Post Back. That's whats makes this forum work.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.