Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re-fitting a 240 sill mould 200 1992

Hi BrickBoard!

I just had our 240 fully re-sprayed after some dodgy insurance work 20-ish years ago. The inferior paint used by the Volvo approved body shop went matte after a few years and the lifetime warranty advertised by our insurer (no name mentioned) evaporated when needed. Anyway, this is not a whine but a call for assistance.

The right side sill mould needs re-fitting as only two clips were left holding it after a lengthy sojourn in this panel shop. I have bought the requisite 13 new clips but see no way of fitting them. There is a protruding bit on each clip that won’t allow them to go anywhere near the mould. There is a great pic at http://www.skandix.de/en/spare-parts/body/body-parts/trim-parts/trim-moulding/clip-body-trim/1027188/. The Volvo original part number is 1304520. The problem part of the clip is the bottom leg of the plus sign the clip resembles (if you squint ;-).

Does anyone have any experience using these clips? Do I need to trim this portion of the clip? I’d seriously appreciate any advice before I re-visit the panel shop.

Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Re-fitting a 240 sill mould [200][1992]
posted by  Rman  on Thu Sep 17 01:09 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.