Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2010 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Bleeder screws that work 200 1992

The hex on the front caliper bleeder screw became a size that no wrench would fit.

The thread for that bleeder is 1/4-28. Napa part number 27864 fits and works. The hex is somewhat more substantial then the stock screw.

The rear ATE caliper bleeder is an M7-1.0 pitch thread. Napa part number 23928 works for those.

Not having tried these on your car, you will have to make sure that they work for you. Brakes are important...

Greg








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Bleeder screws that work 200 1992

    Greg they sound like a great replacement. What do you think the metalurgic makeup is on them?








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Bleeder screws that work 200 1992

      Probably the same recycled Renaults that the originals were made out of. For a couple bucks each, I'm replacing them when I flush the brake fluid. Napa has the caps for them too, but you have to get 10 at a time.

      Greg







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.