Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Seat belt assembly compatibility among 240s 200 1984

posted by  Lord Volvo on  Sat Oct 4 15:41 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 4 15:55 CST 2014
[RELATED]

My driver's side seat belt assembly that mounts just above the rocker panel has the two lower chassis mounts rusted away. The upper two are fine but not enough for safety's sake. So I need to get another one from a donor car.

I assume that I can only use belt assemblies from 1979-ish to 1985 240s (?). But will the passenger side belt assembly work on the driver's side? Do any other assemblies fit into that cubbie hole and the receiver in the middle of the car? The later 240s appear to have different latches which I assume won't fit into the earlier receivers such as in my '84.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Seat belt assembly compatibility among 240s 200 1984

posted by  porkface on  Sat Oct 4 18:01 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:12 CST 2014
[RELATED]

just get both halves from any 240 you like. any set will bolt into any car. good luck, chuck.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.