Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2006 120-130 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

b18 bottom end gasket kit pieces 120-130

posted by  someone claiming to be rob m on  Fri Apr 25 19:35 CST 2014 [RELATED]

I was hoping someone could help me identify the bits that came with my bottom end kit. I have identified most of the gaskets, but the large and small o-rings, the brass crush rings, and the large flat washer, I am unsure about. Thanks.









  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    b18 bottom end gasket kit pieces 120-130

    posted by  someone claiming to be rob m on  Fri Apr 25 19:36 CST 2014 [RELATED]

    https://imgur.com/p2PrEmf








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      b18 bottom end gasket kit pieces 120-130

      posted by  planetman on  Fri Apr 25 20:10 CST 2014
      Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
      last visit: Fri Oct 24 09:29 CST 2014
      [RELATED]

      Hello,

      The 2 seals in the upper left are the oil pump seals which you should not use as they are crap. I strongly suggest you get original oil pump seals.

      Moving left, the 2 copper washers are for the the oil temperature sensor bung in the side of oil pan that came on Volvo 1800 and the other is for the oil drain plug.

      Continuing left are the rubber seals for the large water pump pipe and the large diameter breather box.

      Moving straight down are the seals for the water cooled oil cooler that came on some of the Volvo 1800.

      Continuing down, the large oring is for the oil cooler adapter. I can not recall what the little oring inside the large oring is for.

      The large flat washer is for the oil filler/breather cap.

      The rubber ring that is left and slightly above the oil filler cap seal is for the smaller diameter breather box.

      The rubber ring to the left by itself is for the small diameter water pump pipe.

      And the paper gasket is for the cold start fuel injector for the injected early Volvos.
      --
      Eric

      Hi Performance Automotive Service (formerly OVO or Old Volvos Only)

      Torrance, CA 90502








      •   REPLY TO THIS MESSAGE    PRINT   SAVE 

        b18 bottom end gasket kit pieces 120-130

        posted by  someone claiming to be rob m on  Fri Apr 25 21:39 CST 2014 [RELATED]

        Hey, thanks a ton. That saves me a lot of pulling stuff off to see if Im missing something that needs replaced.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.