Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2013 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Front Engine Seal Questions 900

posted by  Hoola on  Mon Mar 24 07:24 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Apr 13 17:42 CST 2014
[RELATED]

Hello. 1994 Volvo 940 non turbo 286,000 miles. I am in midst of timing belt & oil seals(3x)replacement.

Question 1 : I removed metal cover plate that goes over crankshaft and intermediate shaft. In doing so ruined gasket that goes between this cover plate and engine block. How important is this gasket ? There is no pressure here. In fact it is open on bottom. Can I just fabricate one out of thick paper ? Or should I just order one and wait to finish this job ?

Question 2 : Just how far in should I push new seals ? Ones in there are pretty much flush to front. However I note they could be pushed in further. As much as a 1/2" further for Cam & Intermediate and as much as an inch for crank seals.

Thanks very much for advice & replys.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front Engine Seal Questions [900]
posted by  Hoola  on Mon Mar 24 07:24 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.