Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2025 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

replacing rear wheel seals and bearings 200 1990

posted by  Jac912 on  Wed Feb 26 06:13 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 18 10:43 CST 2014
[RELATED]

My daughters '90 240 has developed the telltale rumble and hum of a failing rear wheel bearing. Reading my Bentley manual they are straightforward in describing the replacement procedure .. but I'm not sure how careful I have to be in removing the seals and bearing. They speak of pressing them out. I don't have the axel out yet so I'm not looking at it but does the bearing just sit in a race? Does it not just pop out? Or if pressed in can I stick some claw tool in there and pry it out? Thanks guys.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replacing rear wheel seals and bearings [200][1990]
posted by  Jac912  on Wed Feb 26 06:13 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.