Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2012 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

got the relay from Eric, the 76 is thus far running great, the 89 however has both motor mounts broken 200

I have both mounts off but is there a logical simple way to re-install when you only have a floor jack?

Kris








  REPLY TO THIS MESSAGE    PRINT   SAVE 

got the relay from Eric, the 76 is thus far running great, the 89 however has both motor mounts broken 200

Floor jack and short length of 2x4 positioned at edge of oil pan. Note this is NOT on the oil pan. I have not damaged one yet.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

A less freaky alternative 200

Maybe try this instead

-Spencer








  REPLY TO THIS MESSAGE    PRINT   SAVE 

got the relay from Eric, the 76 is thus far running great, the 89 however has both motor mounts broken 200

Hi Kris

FYI. This is how I did it. Please be careful.

 photo IMG_0737.jpg








  REPLY TO THIS MESSAGE    PRINT   SAVE 

got the relay from Eric, the 76 is thus far running great, the 89 however has both motor mounts broken 200

Jack the engine up by the front crank pulley, do NOT jack the engine up by the oil pan, you will crush it!








  REPLY TO THIS MESSAGE    PRINT   SAVE 

got the relay from Eric, the 76 is thus far running great, the 89 however has both motor mounts broken 200

Thanks Swedish and Jorrell.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.