Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2012 120-130 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Heavy front sway bar on pre '65 body 120-130

posted by  Danny on  Mon Jul 29 14:47 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 6 22:01 CST 2014
[RELATED]

I have a 1" IPD sway bar on a '67 that I was going to swap onto an earlier 122, only to find that the earlier body only has one hole for each bracket, where the later body has two.

Solutions from those of you who have come up against this would be welcome.







  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Heavy front sway bar on pre '65 body 120-130

    posted by  Phil S. on  Mon Jul 29 17:08 CST 2013
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Oct 24 13:18 CST 2014
    [RELATED]

    Drill all the way through the frame section and use a long bolt with a washer and nylock nut. I've done it a couple times and it seems to hold up just fine.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.