Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

spindle 200 1991

How do I remove the spindle from a 1991 240? I'm changing wheel bearings and the old outer wheel bearing is stuck on the spindle and I can't get it off. A mechanic suggests I may need to get a new spindle, but I need to get the old one off first. Any suggestions?








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    spindle 200 1991

    The spindle isn't separate from the strut eg.
    http://www.fcpeuro.com/products/volvo-suspension-strut-housing-right-w-abs-740-760-780-940-960

    Try cutting off the bearing with a Dremel tool.
    --
    1980 245 Canadian B21A with SU carb, M46 trans, 3:31 dif, in Brampton, Ont.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    spindle 200 1991

    What exactly do you mean? That the nut and washer are off and the outer wheel bearing ( small one ) is preventing the hub from coming off the spindle, or do you mean one of the inner bearing races is stuck on the spindle and the hub is off with it left behind?







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.