After taking an account of what I would need to redo my djet harness, I find that the wires going to the throttle positioning sensor have come completely out from the plug.

I looked up the wiring in the manual. I'll have to go back to the ECU and locate pins 17, 14, 20, and 9. I just do not know if I should start 17 from the bottom of the plug connector or the top. Anyone do this before and know how the wiring should orient?

_______ OR ________
| 17 | | 9 |
| 14 | | 20 |
| 20 | | 14 |
| 9 | | 17 |


Thanks.

Most of the harness wires have the number printed on them.
--
George Downs Bartlesville, Oklahoma

You were absolutely right. I was able to locate 3 out of 4 numbers after cleaning off the wires of years of dirt. That certainly saved some time!

Thanks very much, George.

- Jack

I see the formatting didn't come across very well in the message.

After perusing the green book, under fuel injection there is a page showing pinouts and a diagram for the djet harness. It appears that the pin outs should be from top to bottom on the plug:
9
20
14
17

I'll give that a go. Afterall, it is a rate of chance that it'll be correct.

The TPS itself is likely embossed with the wire numbers right next to the receptacle. I don't know if they all do, but I've seen the numbers on the later produced switches (those with covers that snap into place rather than using flathead screws).

Best,

Cameron
Rose City