Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2011 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

AMM 200 1989

Just curious, how many wires are supposed to be inside that AMM?.... When we cleaned the outside screening, there were 3 wires... Like a box, with an open end. Is there supposed to be 4 wires in there?.... I remember on my 83, there was just 1 wire... So, when looking, I only expected 1 wire, and saw 3.. Should there be 4?.... Also, there was a little bit of gunk on one of the wires, and part of me wanted to try and clean it off, but the rational side of me said to just leave it alone... So I left it alone. I've heard from a few people it's best not to spray it with anything, or even look at it funny... Very delicate and very expensive, even rebuilt.. Can anyone shed some light on this for me?... Thanks in advance.

-Capt. Borkenstein








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    AMM 200 1989

    Hi,

    If memory serves me correctly just 3 wires.

    Some people say to leave the AMM alone-don't clean it. The burn off function takes care of things.

    Some people like to clean it with spray.

    I spray it using CRC AMM cleaner. Every now and then I will remove the AMM, especially if I am doing something in that area of the engine comparment and give each side a quick 2 second spray. I have done this to a 90 244 and 92 245 dozens of times with no AMM failures.

    Travis







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.