Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2014 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Ball joint quality- Moog or Meyle? 200 1992

posted by  someone claiming to be Teal 240 on  Tue Mar 27 16:45 CST 2012 [RELATED]

I'm going to be ordering a bunch of front end parts and wanted input from the group- are Moog parts worth the extra $? I did my 93 with Moog years ago and they have held up fine, but money is tight (when isn't it?) and I wanted to know if folks have had good luck with Meyle parts. I have to say it's great to be back (the 93 has run with very few problems over the last few years so I haven't posted) and with the new 92 added to the fleet, It's great to be back posting to this forum, it's like coming home again. Thanks in advance, Greg








  REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

posted by  someone claiming to be on  Wed Dec 31 18:00 CST 1969 [RELATED]

Greg,

If I were in the market for balljoints I'd get the new problem solver series from MOOG as they have grease fittings and an improved boot design. The older style boots have a tendency to tear. The part numbers are different on them. I see them on both EBAY and Amazon. Shop around as prices vary from seller to seller. For some reason the part houses like FCP and eEuro don't carry them.

example



Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.




<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.