Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2012 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

intake manifold gasket with cracks 900 1994

posted by  Volvo945 on  Tue Dec 27 18:15 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 12 15:05 CST 2013
[RELATED]

As I posted earlier the 944T is idling at 2K RPM. It was suggested I look for air leaks. Examining the intake manifold unions with the head and I see the new gasket (9 months old, aftermarket from FCP) is cracked in ports 1 through 3! I'll pull the manifold off tomorrow to see if the cracks extend into the chamber and to renew it, probably with OEM. Right now these cracks are prime suspects to my starting and idling issue.

So did I overtorque the manifold to cause these types of cracks? I don't know if you can see from the pic but the gasket appears to be splayed outwards.

What is the torque spec on the intake manifold? I can't seem to find it listed in various reference sources. Is there a tightening sequence I should follow?

Thanks for all wisdom shared!
Doug
--
'94 945t; '95 854 base; '05 S80 2.5T







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New intake manifold gasket with cracks [900][1994]
posted by  Volvo945  on Tue Dec 27 18:15 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.