I have pictures if anyone is interested, but for general information, I made a pretty nice looking padded dash cover for the 64 money pit that has used up a lot of my time in the past 2+ yrs. I used high density foam and covered it with black vinyl. The ends (next to the windshield posts)are not exactly right. The vertical trim pieces on the inside of the windshield posts do not fit the dash pad. However, I think they are for a pre-64, because they have a molded piece of rubber ATTACHED to the metal part. My previous 64 had a small adjustable metal extension at the bottom to fit the dash pad.
If anyone needs this type of trim piece, they are available. Or I would trade for or buy the type with metal extension on the end. Replies or questions appreciated.

I'd be interested in the pics. i have to replace my dash pad and would sure like to avoid the $300+ price tag.
thanks
Dean

Dean, I just installed a new dash pad, and it ain't easy. It turned out fine, but I can probably give ypou some tips that might help. The one for sale @ $250 is $63.00 under cost. skeet

Well, long story short-I have ordered the high dollar aftermarket dash pad. I just could not get the ends right on the one I made where the bottom of the pillar trim fit properly. It does look good, but I just wasn't satisfied. Thanks for asking. Skeet

Thanks Skeet
Dean

Dean, I'll sell you a brand new one, never used, for $250.

I would be interested in the dashpad.

Paul

malloy1_at_prodigy_dot_net