Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2008 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

OK, where is the bolt at the rear of the cam cover? 900

I'm trying to remove the cover and removed all bolts on the top but I can't see or feel the bolt I have read is on the rear of the head. Can anyone lend a virtual helping hand?

thanks~








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    OK, where is the bolt at the rear of the cam cover? 900

    Just took mine off 10 minutes ago and did not remove anything at the firewall end. Just the combination of nuts and acorn nuts (total 8) on the top.

    Brian Mee

    92 945T








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    OK, where is the bolt at the rear of the cam cover? 900

    edit: the below assumes a 940 with B230F or FT.

    The valve cover is held on by the ten acorn nuts on top, there's nothing around back holding it on. If it is being reluctant to budge and all 10 nuts are off, most likely someone did a very thorough job of slathering gasket-goo onto the curved mating surfaces at each end, and that gunk is holding it on.

    john
    --
    1989 245 233K / 1993 945 127K







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.