Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2012 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

For it/against it 200 1989

posted by  B0RK ^3 on  Thu Apr 21 16:10 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 15 18:09 CST 2014
[RELATED]

Redline MTL for an M47?








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    For it 200 1989

    posted by  ZJZ on  Thu Apr 21 16:42 CST 2011
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Mon Oct 13 14:29 CST 2014
    [RELATED]

    For








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      For it 200 1989

      posted by  JimN696 on  Fri Apr 22 04:57 CST 2011
      Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
      last visit: Mon May 6 17:14 CST 2013
      [RELATED]

      Definitely for. Smoother shifting, quieter operation. Extended the life of an ailing unit substantially before needing a rebuild.
      --
      http://www.facebook.com/album.php?aid=53563&id=1189132524&l=75a2564d60








      •   REPLY TO THIS MESSAGE    PRINT   SAVE 

        For it . need some education here 200 1989

        posted by  oldduke on  Fri Apr 22 06:55 CST 2011
        Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
        last visit: Sun Feb 2 13:04 CST 2014
        [RELATED]

        hi sages- what is redline mtl and how is it better for the m47. think the one in my 92 calls for atf. does redline have any special additives? synthetic? where do you get it? sounds like a truckstop lubricant on route 95. 2 quarts sounds like too much.know with chrysler 3 and 4 speed stickshifters if you overfill, it gets squeezed out the input bearing shaft or tail shaft bearing. actually dont like atf in manuals because it is so thin, slow seepage is common. seepage from input shaft bearing/gasket can lead to clutch slippage and short clutch life. from what i have recently discovered about cost to rebuild m47s or get one from a junkyard clipper, i would like to maximize the life of the one i have. thanks tons oldduke







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.