Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2005

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

90-240 Lemfoerder&Scan-tech control arm bushings.

I recieved this brand mix of control arm bushings from FCP several years ago:

1 lemfoerder(rear)
1 scan-tech(rear)
2 scan-tech(front)

Im preparing to change the bushings on my control arms, and my thoughts are to change the 1 rear scan-tech for lemfoerder and use the scan techs in the front.
Are should I go with lemfoerder all around?

I want to start on this today and would appreciate any comments or observations.

Thanks














  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

90-240 Lemfoerder&Scan-tech control arm bushings. 200 1990

The ScanTechs will probably not last as long as the Lemforders.
It would be good if you put the MODEL/YEAR that pertains to your car rather than leaving them ALL/ALL.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

90-240 Lemfoerder&Scan-tech control arm bushings. 200 1990

It is my understanding that the front bushings dont wear as fast as the back ones. I could be wrong. I have seen at least one situation where the back ones were toast and the fronts were pristine. Thats why I thought this mix might work?
I have noted your comment about properly posting my car.

Thanks







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.