Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2008 1800 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

front hood support - won't extend 1800

After selling my restored 122 wagon to a happy owner, I've been working on a 1970 P1800 that I picked up last winter. Although I learned a huge amount restoring the 122, I know I'll have a more than a few questions to ask re: the the P1800.

So here goes....I removed the front hood and the hood support arm. When I removed the support arm it was extended and locked into place. Later I pushed the extended part of the support back into the collapsed (or un-extended position). However, now I can't unlock the thing to extended the arm again. It seems locked forever in the collapsed state. I've tried poking things into the side slider rails in hopes of unlocking something so I can pull it to the extended position, but no luck.

Anyways, this seems like a dumb problem but there must be a solution.

Thanks all

Waggin

1965 122 wagon (now happy in a new home)
1985 240 turbo wagon
1970 P1800









  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    front hood support - won't extend 1800

    I don't know why it wouldn't slide to the open position there only seem to be 1 way it it could be installed. The push tap on the arm is spring loaded.Maybe the 2 arm section are installed upside down. If you would like I will send you a picture of the one installed in my 1800e....e-mail lbtecra@yahoo.com

    bob







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.