Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2011 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear rotor thickness 200 1986

I'm going to replace my front rotors and pads next week (78K miles). I was going to replace my rear pads also (same mileage). What should the rear thickness be before they need to be replaced? I know the fronts take most of the use and abuse.

Thanks for your thoughts and input.
--
'86 sedan with 430,000 miles on the original engine and automatic transmission








  •   REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

    I was looking to get the thickness for the rotor instead of the pads.

    --
    '86 sedan with 430,000 miles on the original engine and automatic transmission



    Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.





  •   REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

    3mm. But the last time I replaced my rear pads they were about 5-6mm. They had been on there for many years and I just got tired of waiting for them to wear out.
    --
    1986 Volvo 245



    Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.





  •   REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

    New pads are about 10mm give or take,this is pad thickness,not the metal backing.If the rears are more than half,I usually replace them.


    Dan



    Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.




<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.