Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2023 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Bulb Diameters 200

Is it just me, or has anyone else noticed that the 1157 bulbs fit very loosely in the holder? I did not notice this with the original Euro bulbs.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Bulb Diameters 200

No, haven't noticed any variation in the base, but your subject line immediately brought back a sorry memory about trying to get a bulb out of a partially melted Taiwan-made aftermarket wagon tail light, made difficult because the bulb seemed to have grown. :)

I believe the base is supposed to be 15 mm in diameter.
--
Art Benstein near Baltimore

Always read stuff that will make you look good if you die in the middle of it.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Bulb Diameters 200

Thanks Art.

Mine appear to be loose in the socket. In fact, I've run a spot of solder on them to make the barrel tighter in the socket. It makes for a much better ground.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.