Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 120-130 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

speedo problem 120-130

Hi,

I've been trying to get my speedometer to work for years now and I think I've found the problem but don't know how to fix it. The dash speedo works, the speedo cable is just fine, and the speedometer gear that goes into the transmission is just fine. But, the gear turns freely instead of being locked into place by the driving/worm gear inside the transmission (an M41). I pulled the transmission (for some other reason) and I noticed that the worm gear was shifted back (toward the driveshaft). I think there is supposed to be a spacer that fixes the worm gear into place - maybe that has gone somewhere?? I've put the transmission back into the car (cause - well - its my only way to get around) and don't want to pull it again, but I am wondering if anyone has had this problem or might have an idea how to fix it.

Thanks!

Nicholas
1966 122 wagon
1965 P1800
1964 VW beetle








  REPLY TO THIS MESSAGE    PRINT   SAVE 

speedo problem 120-130

Hello,

Do you have a D or J type overdrive?

The D has the solenoid mounted on the right hand side and J is mounted on the left hand side of the overdrive.
--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502








  REPLY TO THIS MESSAGE    PRINT   SAVE 

speedo problem 120-130

I have a D overdrive. So, the entry point for the speedo cable and gear is on the same side as the solenoid.

For a different reason I switched transmissions in my P1800 and 122. This is how I know that the problem lies in the transmission, not any of the other components.

Thanks for any ideas!

Nicholas








  REPLY TO THIS MESSAGE    PRINT   SAVE 

speedo problem 120-130

Hello,

Someone probably left out the thin spacer ring that goes on after the speedometer flange and thick spacer on the output shaft of the overdrive.

Without that thin spacer, the speedometer flange will spin freely and not turn the speedometer drive gear and therefore will not turn the cable.

If the thin spacer is missing, you will have to remove the overdrive and disassemble to properly repair.

The J overdrive does not use a spacer in this area and someone may have confused the 2 and assumed there was no spacer needed.

BTW, there are almost no interchangeable parts between the a D and a J overdrive.
--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502








  REPLY TO THIS MESSAGE    PRINT   SAVE 

speedo problem 120-130

That's too bad. Oh well, I'll wait until it needs to be rebuilt.

Thanks.

Nicholas







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.